P0022 — A Camshaft Position - Timing Over-Retarded (Bank 2)
Moderate severityWhat it means
P0022 is stored when the engine control unit sees a fault involving the “A” (typically intake) camshaft timing/actuator on bank 2. Variable valve timing rotates the camshaft to optimise power and economy across the rev range; the control unit drives an oil-control valve and watches the resulting cam angle. “Timing over-retarded” means the variable valve-timing system is lagging behind the commanded camshaft angle, so valve timing is out.
Common symptoms
- Rough running, low power or a start-up rattle
- Rough idle or a start-up rattle
- Loss of power or poor economy
- Hesitation at certain RPM
Likely causes
- A stuck or sludged camshaft phaser
- A faulty oil-control valve or low oil pressure
- A clogged oil-control valve or dirty/low oil
- A worn camshaft phaser or timing-chain stretch
What to check first
- Check oil level and condition, then compare commanded vs actual cam timing in live data
- Check oil level and condition first
- Inspect the oil-control valve and its connector
Can you keep driving?
Often drivable, but timing faults hurt power and economy and can stress the chain — diagnose soon.
Frequently asked questions
What is the most common cause of P0022?
The most likely cause is: A stuck or sludged camshaft phaser. Several other faults can set P0022 as well, so confirm the real cause with live data and the checks above before replacing any parts.
Can I just clear P0022 and keep driving?
Clearing P0022 with an OBD2 scanner turns the warning light off, but if the underlying fault has not been repaired the code will usually come back within a few drive cycles. Fix the cause first, then clear the code to confirm the repair worked.
How serious is P0022?
P0022 is a moderate-severity code. The car is often still drivable, but have it diagnosed soon — the underlying problem can get worse and it may fail an emissions test.
Scan, log and diagnose with MechanicAI
Plug a Bluetooth OBD2 adapter into your car and let MechanicAI turn raw data into answers:
- Scan, read and clear fault codes in seconds
- Inspect every sensor with live data
- Create instant logs and automatic trip records
- And above all — analyze it all with AI for the most likely cause and clear next steps.
Related codes
All information, explanations and guidance on this page are general preliminary information only. They are estimates and may be entirely wrong, incomplete or inaccurate, or may not apply to your vehicle at all. Never take any action based on this content alone — do not decide to keep driving, clear codes, replace parts, repair or otherwise work on your vehicle based only on what you read here. In every case, and for any final decision, you must consult qualified technical personnel (a professional mechanic, an authorized service centre or an engineer) and obtain their approval before acting. MechanicAI accepts no liability or responsibility whatsoever for any damage, fault, injury, loss or outcome that may arise — directly or indirectly — from using or relying on this information, for any reason and under any circumstances. By using this page you acknowledge and accept these terms.