P0202 — Injector Circuit/Open - Cylinder 2
High severityWhat it means
P0202 is stored when the engine control unit sees a fault involving the fuel injector circuit for cylinder 2. The injector sprays a metered amount of fuel into cylinder 2; a circuit fault means that cylinder is not fuelled correctly, which usually shows up as a misfire on that cylinder. The “open” status means the control circuit is electrically broken — usually a cut wire, an unplugged connector or a failed driver.
Common symptoms
- The component does not respond to commands
- Rough idle and engine shake
- Hesitation or power loss
- A misfire on cylinder 2
- Fuel smell or higher consumption
Likely causes
- Open or broken wire in the control circuit
- Unplugged or corroded connector
- A failed or clogged injector on cylinder 2
- A driver-circuit, wiring or connector fault
What to check first
- Check circuit continuity and connector pins with the key off
- Check the injector connector, wiring and resistance
- Swap the cylinder 2 injector with a neighbour and see if the fault follows
Can you keep driving?
An unfuelled cylinder misfires and can overheat the catalytic converter; limit driving until it is repaired.
Frequently asked questions
What is the most common cause of P0202?
The most likely cause is: Open or broken wire in the control circuit. Several other faults can set P0202 as well, so confirm the real cause with live data and the checks above before replacing any parts.
Can I just clear P0202 and keep driving?
Clearing P0202 with an OBD2 scanner turns the warning light off, but if the underlying fault has not been repaired the code will usually come back within a few drive cycles. Fix the cause first, then clear the code to confirm the repair worked.
How serious is P0202?
P0202 is a high-severity code. Diagnose and repair it as soon as possible, because continuing to drive can cause further damage or leave you stranded.
Scan, log and diagnose with MechanicAI
Plug a Bluetooth OBD2 adapter into your car and let MechanicAI turn raw data into answers:
- Scan, read and clear fault codes in seconds
- Inspect every sensor with live data
- Create instant logs and automatic trip records
- And above all — analyze it all with AI for the most likely cause and clear next steps.
Related codes
All information, explanations and guidance on this page are general preliminary information only. They are estimates and may be entirely wrong, incomplete or inaccurate, or may not apply to your vehicle at all. Never take any action based on this content alone — do not decide to keep driving, clear codes, replace parts, repair or otherwise work on your vehicle based only on what you read here. In every case, and for any final decision, you must consult qualified technical personnel (a professional mechanic, an authorized service centre or an engineer) and obtain their approval before acting. MechanicAI accepts no liability or responsibility whatsoever for any damage, fault, injury, loss or outcome that may arise — directly or indirectly — from using or relying on this information, for any reason and under any circumstances. By using this page you acknowledge and accept these terms.